-
Notifications
You must be signed in to change notification settings - Fork 0
6. Removal
Jeff Chen edited this page Sep 15, 2023
·
1 revision
Thinking forward, in case you feel the need to go back to 4MB, here are some of my thoughts.
Instead of removing the mod You may want to do either of the following:
- Remove the resistors from the adapter boards (easier)
- Build a batch of single-sided modules
To actually remove the adapter boards from the card, my suggestions would be:
- Wick away as much as possible solder from all the joints first
- Using a very thin metal feeler gauge (preferably made of stainless steel), heat up the connection that's still attached with an iron and slice through it with the gauge.
- However, make sure the four corners on the outer most edges are disconnected last, this way the adapter board would stay in place for most of the time and risk of tearing pads is reduced.