Nv3007 _142x428 / RP2040

[JaelAra]

Hi everyone, sorry I was trying to use PDQgraphictest example with raspberry Pico and nv3007 with the next pins:

1. SDA
2. SCL
3. RS
4. RESET
5. CS
6. FMARK/TE
7. VDD
8. LEDK
9. LEDA
10. GND

I have been following the instructions in the main code, but I can't get initialize this LCD

1. I have configured display.h whit nv3007
2. Databus.h /Arduino RPiPIcoSPI SCK 18 , MOSI 19, MISOI 16, (,spi0 :spi?)
3. Pins.h : (TARGET RP2040) CS 17, RST 26, DC 27, BL 28
4. Device.h (I couldn't find any option to uncomment for nv3007)

If upload the code as this configuration nothing happen in the screen remains off, how could initialize this display in a correct way ?
thanks for your help.
Regards !

[moononournation]

In PDQgraphictest example, there are a Arduino_GFX_display.h header file. Comment out the declaration of ILI9341 and then uncomment the NV3007 one.

[JaelAra]

I have already comment the header file and uncomment nv3007 option at first , I was thinking that could have omit another configuration or have a pin connection wrong because the screen is totally off , for example in device.h file I couldn't find any configuration for nv3007 that I could uncomment as the instructions suggest , thanks for your help , regards !

[moononournation]

manual connect display not using dev device header file

[JaelAra]

Ok I see , then nv3007 could work without device header file by default, then could be probably a problem with the pins connection, It is correct the way to connect RP2040 as my first message?because I been trying to connect it in a lot of ways without any change because still off , that's why I want to be sure that I am not omitting something Thank you for your help