Flux Infill with svdq-int4-flux.1-fill-dev

[joshuaromkes]

Looking to get infill working with this model:
mit-han-lab/svdq-int4-flux.1-fill-dev

I love the non-fill model (mit-han-lab/svdq-int4-flux.1-dev) for image prompting, its the fastest i've seen with flux with almost zero quality change to the native version. but with fill, it does not seem to work using a standard swarm workflow. the same method works fine with the native fill model from BFL.

if anyone has any suggestions to make it work, happy to hear it. below is an example

here's the prompt I used

Model: Flux/flux1-fill-dev, Seed: 123456789, Steps: 60, CFG Scale: 1, Aspect Ratio: Custom, Width: 504, Height: 336, Sampler: Euler, Scheduler: Normal, Flux Guidance Scale: 30, Init Image Creativity: 1, Init Image Reset To Norm: 1, Automatic VAE: true,
date: 2025-04-30, used_image_editor: true, prep_time: 38.03 sec, generation_time: 2.25 min, Swarm Version: 0.9.6.0,

[mcmonkey4eva]

Make sure you edit the Architecture metadata on the model to be Flux 1 Fill, otherwise it will autodetect as Flux Dev most likely

[joshuaromkes]

and that's what it was, explains why the other models failed to work also! thank you! I knew it was something simple