a problem about the loginlet boundary condiation

[smallduan]

Hi

I am trying make a wave tank with wind as the Chapter_7 shows, but I find the wind con't keep the input U as I wnat it do.

all the simulation is based on the tut in waves2Foam(waveFlume) with a inlet coded boundary (U = (1 0 0) m/s when y-0.2>0.01). Can you tell me the possible reasons for the failure?

Best regards

[fronterapp]

Hi,

I'm not sure about what might be causing this, but itseems like the inlet boundary condition (pressure-velocity) is not correctly specified. Does it also happen if you run the vanilla example from this repository, without modifying the inlet condition?

Best,
Pere