Inner Shoulder x2.stl

[chadakenn]

Inner Shoulder x2.stl need sized up its a little small and wont screw in

[chadakenn]

or i guess Drum x2.stl might need scaled down ill have to print the tpu tire and see

[ammmze]

Looks like I have a 0.2mm clearance on there. Perhaps I should add a slight taper so that starts with a 0.2mm clearance and then reduces to 0.1 or 0.15. That should allow it to wedge in a little as you screw it in.

[chadakenn]

Looks like I have a 0.2mm clearance on there. Perhaps I should add a slight taper so that starts with a 0.2mm clearance and then reduces to 0.1 or 0.15. That should allow it to wedge in a little as you screw it in.

I never got to print the tpu as my print isn't tuned 100% for tpu yet so I skipped the wheels so I'm not 100%sure what part is off.... I'm starting a 2ed one and even the slicer could have sliced it wrong so I'll print each one individually and see what happens