README.md

PiOLED display plugin for the Pioreactor

Display growth rate, normalized OD, and temperature for each Pioreactor using the Adafruit PiOLED display

Hardware required

• Adafruit PiOLED display
• 0.1" 2x20-pin Strip Right Angle Female Header

Software installation

Install from the UI, or run:

pio plugins install pioled-display-plugin

You may get a "hardware not installed" error. That's okay, we'll do that next.

Hardware installation

With the Pioreactor turned off (you can pull the plug), install the 2x20 right-angle header onto the the 2x20 header on the Pioreactor HAT. Attach the PiOLED display onto the right-hand side of the new header, with the orientation as shown in the image below:

Power back on the Pioreactor.